Common Leak Sources & Warning Signs
Supply System
Angle stops, braided supplies, and solder joints behind cabinets or in basements/attics. Look for hissing, water stains, or rising bills.
Drain & Fixture
P‑traps, tub/shower drains, and toilet seals. Watch for musty odors, ceiling spots below baths, or damp vanities.
Our Leak Repair Approach
- 1.Moisture mapping and targeted opening (only where needed). We protect surfaces and isolate the leak section.
- 2.Permanent fix using quality materials—sweated copper, press fittings, PEX with proper supports, or trap/gasket replacements.
- 3.Pressure testing and dry‑out guidance to prevent mold growth. We can refer mitigation partners when necessary.
DIY: Quick Checks Before Calling
- Shut off suspect angle stops and see if meter movement stops.
- Inspect supply hoses at toilets, sinks, and washers for bulges or corrosion.
- Place paper under the P‑trap to confirm a drip location.
If the meter still spins or moisture shows in ceilings/walls, call us—hidden leaks can escalate fast.
Materials & Best Practices We Use
- Type L copper, press systems, or PEX with expansion fittings depending on application
- Full‑port valves and quality flex connectors to reduce future failure points
- Support and isolation to stop vibration on long runs
- Water‑safe sealants and gaskets on drains to prevent early degradation
Our goal is to fix the leak—and the reason it occurred—so you’re not revisiting the same area in six months.
Insurance & Documentation
We provide photos and written findings for insurance claims when leaks cause sudden damage. Our invoices detail the cause, location, and permanent repair performed.
What Affects Cost & Timeline
Access and finish protection are the largest factors. Hidden wall/ceiling leaks require careful opening and restoration coordination; under‑sink or mechanical room leaks are quicker. We provide clear pricing before work begins and communicate if scope changes after opening.
- Simple fixture/supply leaks: typically completed within an hour
- Hidden line repairs: allow additional time for locating and testing
- Multiple leaks or corroded systems may suggest short reroutes for reliability
After‑Repair Care & Prevention
- Check repaired areas over the next 48 hours to ensure everything stays dry.
- Replace old supply hoses with braided stainless every 5–7 years.
- Keep shutoff valves exercised—turn them off/on twice a year so they don’t seize.
- Consider leak sensors near water heaters, washing machines, and under sinks.
We’ll show you where your main shutoff is and how to shut water quickly in an emergency.
Signs It’s Time to Repipe or Reroute
If leaks recur in different spots or the system shows heavy corrosion, targeted repairs become band‑aids. Short reroutes or partial repipes reduce future risk and can be more economical than chasing leaks.
- Multiple pinholes in copper or frequent slab leaks
- Visible corrosion on long exposed runs
- Low water pressure caused by internal scaling
Frequently Asked Questions
Can I leave the water on while you diagnose?
We may ask you to keep it off until we arrive to prevent additional damage. We bring temporary supplies to keep essentials running during repair when possible.
Do you repair drywall?
We leave openings neat and ready for finish repair. If you prefer, we can coordinate with a trusted finisher.
Will PEX reduce future leaks?
When properly supported and protected from UV and abrasion, modern PEX is very reliable and ideal for reroutes around problem areas.
FAQs
How do I know if a leak is in the slab?
Warm spots on floors, continuous meter movement, and high bills are clues. We use acoustic and pressure tests to confirm and localize.
Can you repair without tearing out tile?
Often yes—by rerouting or accessing from an adjacent wall/ceiling. We discuss options to minimize finish work.
Do you warranty leak repairs?
Yes. We warranty our workmanship and use quality components to prevent repeat failures.